AX-2210N 1000Kv Brushless Motor

Finaly my 9x6 props arrived. It's a HobbyKing APC Style 9x6  propellor. This is not a genuine APC prop. It is a cheap hobbyking cl...

In this benchmark I have tested a 1045+1147 setup and a 1147+1045. The conclusion is that mounting the largest prop on the top motor causes...

Another combination. This time two 10 inch props with different pitch. Mounting the prop with the highest pitch as bottom prop has again a ...

The 11x47 prop performed well in the single prop benchmarks but in coaxial configuration a huge efficiency loss was set. In the 9x47 + 11x4...

The 10x60 inch prop again suprises in a coaxial benchmark. It seems that using a prop with higher pitch on the bottom motor increases the e...

This is the first coaxial mixed propellor benchmark. Using a different top and bottom prop might have negative or positive influence on the...

The benchmark voor the coaxial 11x47 prop is again suprising, but this time in a negative way. Although this prop proved to perform very we...

The benchmark voor the coaxial 10x60 prop is a little bit suprising. Although this prop didn't perform well in single configuration it ...

Now it's time to bench the 10x45 props in coaxial configuration. It seems that the efficiency loss is higher then with the 9x47 coaxcia...

Here is the first set of results for my coaxial benchmarks.  A little bit of explanation: The column called " 9x47 Coaxial bench...

So here is the comparison table of all my current pusher en puller propellers. All previous tests on the brushless AX-2210N RC motor with di...